Without any lighting Rated Voltage: DC12V Power consumption: Hi beam 30W / Lo beam 30W LED: CREE XLamp XP-L LEDs Color Temperature: 3000K Luminescence Color: halogen bulb color
*Φ180 headlight H4 bulb specification is required for installation.
*The maximum luminous intensity is measured by the headlight attached to LBH-K03 / LBH-K04.In the case of LHL-K01 / LHL-K02, some aftermarket headlights may not meet the standard value due to structural problems. *If the width of the headlight case is too small, please use a commercially available Φ8mm spacer collar. *Install the product correctly according to the instruction manual.Improper installation may result in fire or equipment damage. *Before installation, be sure to disconnect the terminal cord on the minus side of the battery and confirm that the key is OFF. *Please do not touch or get the LED chip dirty.Dirt can cause the LED chip to burn due to heat being built-up.The LED bulb comes with an acrylic cap with a sealing seal. *Please handle this product with care as it is a precision instrument.Do not drop the product or pull the wires forcibly.Improper handling may cause malfunction, injury, burns, or serious accidents that may result in death.In addition, sparks, poor insulation, or short-circuiting may cause a failure of the product or a fire in the vehicle. *Do not disassemble or modify this product in any way.Products that have been disassembled or modified are not covered by warranty. *Do not look directly at the LED light when it is on.It can cause visual impairment. *Do not splash water on the lens while the light is on or immediately after it is turned off.Sudden temperature change may cause damage to the lens or LED bulb.In addition, please do not touch the LED bulb itself, the heat sink behind it, and the controller unit because they get to the high temperature. *This product is for motorcycles only, so cannot be used on four-wheeled vehicles.This product is not for use on automobiles. *Do not cover with paper or cloth and do not light near flammable materials.Failure to do so may result in fire or abnormal heating.Also, do not light near flammable items such as flammable spray, thinner, etc. or items that may ignite. *Do not install to the headlight with the light on.Failure to do so may result in malfunction or burns. *This product is waterproof for daily life, but it is not completely waterproof.Wrap the coupler coming out of the controller unit with vinyl tape or self-bonding tape, or use caulking agent to waterproof it.Avoid wetting the product with more water than necessary. *When washing a vehicle with a high pressure washer, please do not let the high pressure wash directly hit this product. *Please do not drop the LED bulb or controller unit, or give it a strong shock.It not only causes breakage, deterioration of performance and shortening of service life, but also causes injury. *When assembling the LED bulb, be sure to apply the supplied silicon grease to the areas indicated by the grease marks in the instruction manual. *Do not cover up the waterproof fan.Make sure that there is enough space behind the fan for the sucked air to flow. *Use a thread locker to prevent loosening of the threaded part.Periodic retightening is also recommended. *Installation requires expertise and skill.Please have it done at a designated maintenance facility with skilled mechanics. *Please adjust the optical axis before use.It may obstruct the view of oncoming vehicles and cause traffic accidents.
*PROTEC is not responsible for any damage or accident caused by the use of this product.Protec will not be responsible for any labor charges or other costs incurred during repair. *If you feel any abnormality during installation or use, please contact your dealer or PROTEC service department. *There may be changes in product specifications due to the manufacturer's reasons.
The combination of your favorite H4 bulb headlights and Pro-tech H4 LED bulbs provides brightness that far surpasses stock LEDs!
Protec H4 LED Headlight Bulb Kit with W800 compatible headlight connection harness. *Φ180 headlight H4 bulb specification is required for installation.
H4 LED bulb for use in combination with the '19-W800 stock LED headlights when replacing them with aftermarket Φ180mm H4 bulb type headlights. Luminescence color is white 6000 Kelvin. Headlight must be purchased separately.
Do you feel that the stock LED headlights are too dim? '19- The stock LED headlight Lo beam on the W800 is on at 7w and is as bright as a halogen bulb. If you look at the image that LED is brighter than conventional bulbs, you will be disappointed in the brightness of normal LED. Unlike the bulb type headlight, the stock LED headlight can not be brightened by replacing with aftermarket LED. This product enables to install PROTEC H4 LED bulb by replacing the headlight unit, and the headlight will be many times brighter.
Sleek multi-reflector lens The LED base is placed horizontally on the lens surface of the stock LED headlight, so it is heard that many users feel uncomfortable with the design of the headlight. The familiar multi-reflector lens can be used to create a clean look and feel. The headlight is the same size as the stock headlight, so it fits the W800 perfectly.
Available color temperatures are 6000K and 3000K Please select your favorite color from two colors: 6000 Kelvin, which is a typical LED blue-white color, and 3000 Kelvin, which is a classic halogen bulb color.
The maximum luminous intensity is 39,600 candela. The optical axis can be adjusted to the standard range without shifting. Protec has introduced BANZAI's HT-322 headlight tester to measure the headlights during development. *Measured values are based on the headlight supplied with LBH-K03 / LBH-K04.In the case of LHL-K01 / LHL-K02, some aftermarket headlights may not meet the standard value due to structural problems.
Adoption of reliable CREE's LED! A total of 6 CREE XLamp XP-L LEDs (3 for Hi beam and 3 for Lo beam) are used as light emitters.
Waterproof Electric Fan Cooling A really bright LED generates heat due to the large input current and becomes hot. In order to cool down the heat, this product adopts a cooling system with a highly durable waterproof electric fan. It is essential equipment to maintain stable brightness.
Mountable headlight dimensions LHL-K03, LHL-K04 Please refer to the '19- W800 series stock headlight dimensions in the image and prepare the headlight that can be installed separately. *If the width of the headlight case is too small, please use a commercially available Φ8mm spacer collar.
Separately required parts LBH-K03, LBH-K04 The width of the headlight is 175mm. Since the distance between the headlight brackets on the vehicle side is wider, it is necessary to install a spacer collar of 23-24mm thickness on one side between the headlight and the headlight bracket. Please prepare it separately by yourself.Please refer to the following products. k・con Aluminum Spacer Collar [Silver] ・No.0900-093-00031 Φ8.2 / Outer diameter 20 x Thickness 8 - 2pcs ・No.0900-093-00057 Φ8.2 / Outer diameter 20 x Thickness 15 - 2pcs Or, k・con Aluminum Spacer Collar [Black] ・No.0900-093-02031 Φ8.2 / Outer diameter 20 x Thickness 8 - 2pcs ・No.0900-093-02057 Φ8.2 / Outer diameter 20 x Thickness 15 - 2pcs
Points of Attention
* If there may be an instruction manual included, it will be written in Japanese.
* The BEST and MUST store to find Japanese parts. * Register now for amazing deals and other special offers! *Over 800,000 listed items. It's hard NOT to find your parts.
SIGN IN TO WEBIKE JAPAN
Please enter email at least 6 characters.
Please enter a valid email address.
Email is already in use.
Your account has been banned.
Email address and/or password is not match.
Authentication with facebook fail.Please try again.
Please select How did you get to know about Webike Japan?
OR
YOUR ACCOUNT HAS BEEN CREATED!
Congratulations! Your new account has been successfully created! You can now take advantage of member privileges to enhance your online
shopping experience with us. If you have ANY questions about the
operation of this online shop, please email Webike through CONTACT US.
A confirmation has been sent to the provided email address. If you
have not received it within the hour, please contact us.
Get on your grid by register your motorcycle! About our "Mybike" service
"Easier to Search Items" It helps you to search items to fit for your motorcycle!
"Get Much Valuable Information" It helps you to get special deals, newly listed items and closeouts about your motorcycle!
"Easy to Register" It requires only your motorcycle manufacturer, model name and model year!