- Fits:
- KAWASAKI
- KAWASAKI
- KAWASAKI
- KAWASAKI
- KAWASAKI
- ...and more.
Well, it's like this ….It's just right for Refresh for now!Read More - Fits:
- KAWASAKI
- KAWASAKI
- KAWASAKI
- KAWASAKI
- KAWASAKI
- ...and more.
I have often used Tie Wrap, but I had to cut it off and use a new one every time, so I bought it. I am glad I bought it, even though it seems rather expensive.Read More - Fits:
- KAWASAKI Z900 (KZ900) 76-80
- KAWASAKI
- KAWASAKI Z750 (air-cooled) 76-80
- KAWASAKI Z1000 (air-cooled) 76-80
- KAWASAKI Z900 (KZ900) 76-80
- ...and more.
Electric wiring on older cars should be replaced as much as possible, including the 6V MONKEY/GORILLA Main Harness, Regulator, BatteryLEAD, Blinker harness, and Tail lamp.You never know when or where ...Read More - Fits:
- KAWASAKI Z1000A 76-78
- KAWASAKI Z900 76-78
- KAWASAKI Z1 72-75
- KAWASAKI Z1R 1 Type
- KAWASAKI Z2 72-75
- ...and more.
I bought the Coil, Rotor, One way clutch and Rose because the price is not so different from the OEM type. The installation was easier than expected because there is a video of the installation on PMC...Read More - Fits:
- KAWASAKI
- KAWASAKI
- KAWASAKI
- KAWASAKI
- KAWASAKI
- ...and more.
Purchased with Washer.Only Gasket is difficult to prevent from deteriorating.It is a necessity when replacing parts.To be honest, it would be a big help if you could stock only Gaskets by Manufacturer...Read More - Fits:
- KAWASAKI Z1 (900SUPER4)
- KAWASAKI Z1-R/Z1-RII
- KAWASAKI Z1000
- KAWASAKI Z1000 MkII
- KAWASAKI Z2 (750RS/Z750FOUR)
- ...and more.
When reverting from Separate handle to STD Handlebar, the OEM Headlight BracketPurchased to re-install.If the cost was a little cheaper, I could be satisfied, but without this, the Light Bracket is ha...Read More - Fits:
- KAWASAKI
- KAWASAKI
- KAWASAKI
- KAWASAKI
- KAWASAKI
- ...and more.
Before attaching the Meter Wire to the Meter, you must run the Clamp through the Wire or you will have to start over.I've done it.Read More - Fits:
- KAWASAKI
- KAWASAKI
- KAWASAKI
- KAWASAKI
- KAWASAKI
- ...and more.
OEM Parts are still available. The price is not so different. What is the quality of Rubber?Which one shall we choose?Read More - Fits:
- KAWASAKI
- KAWASAKI
- KAWASAKI
- KAWASAKI
- KAWASAKI
- ...and more.
This is a very common part, but you will have to remove the fork to install it, so it will be tricky if you can't adjust it after reassembly. You need to have the right equipment to install this part,...Read More - Fits:
- KAWASAKI Z1000 (air-cooled) 76-
- KAWASAKI Z650 76-21
- KAWASAKI Z750 (air-cooled) 76-
- KAWASAKI Z900 (KZ900) 76-
- KAWASAKI Z1000 (air-cooled) 76-
- ...and more.
It is exchange to the one made by PMC because the thing made at that time in 81 was done. Because it is a part that enters the field of vision, it is good feeling. If you don't care about the thing of...Read More - Fits:
- KAWASAKI
- KAWASAKI
- KAWASAKI
- KAWASAKI
- KAWASAKI
Used with Offset50mm ZapperStem.The wire length is 64.5cm of Standard. 69.5cm of Long Type is also available.Grease is applied to the wire from the beginning.Read More - Fits:
- HONDA VTZ250 (Carburetor)
- HONDA CB750 RC42
- HONDA CB750 Four(CB750K) OHC
- HONDA CB1100 (Injection)
- KAWASAKI Z900 (KZ900)
- ...and more.
I could immediately feel the smoothness of the waking upAfter installing this InsulatorBandBolt, it may change from one individual to another You will need the carburetor resettingWhen I blew on Axel ...Read More - Fits:
- KAWASAKI Z900 (KZ900)
- KAWASAKI Z750-D1 (KZ750D) D1
- KAWASAKI Z750 (air-cooled) A5
- KAWASAKI Z750 (air-cooled) A4
- KAWASAKI Z10012VUniversal
- ...and more.
This horn by Doremi Collection is a Nikko Horn.
There are two sizes available : Large and Small.
I bought the small horn and it is very good in fit and finish.
The connector thimbles are also qui...Read More - Fits:
- KAWASAKI
- KAWASAKI
- KAWASAKI
- KAWASAKI
- KAWASAKI
- ...and more.
Anchor Earth Body, Mount rubber had OEM Product, but I only want RubberColor in OEM shortage. Installation was able to attach with OEM Product without problem. This Blinker ground and RubberDamper are...Read More - Fits:
- KAWASAKI Z1000 (air-cooled) 77-79
- KAWASAKI Z750 (air-cooled) 77-79
- KAWASAKI Z900 (KZ900) 77-79
I thought that it was the same as OEM at first, but it was cut off on about 50 km running.Since I am not a big price difference I will buy OEM next.Read More - Fits:
- KAWASAKI Z900 (KZ900)
- KAWASAKI Z750FX
- KAWASAKI Z2 (750RS/Z750FOUR)
- KAWASAKI Z1000 MkII
- KAWASAKI Z1000
- ...and more.
Rear settled down, but since Front did not fit whatever he thought, he machined it and installed it.PMC products look like this.Read More - Fits:
- KAWASAKI Z1000 (air-cooled) 77-79
- KAWASAKI Z750 (air-cooled) 77-79
- KAWASAKI Z900 (KZ900) 77-79
I used it for 77 kz 1000 A 1, but the Screw on the side of the Meter gear is too deep to fix perfectly, Cable vibrates while traveling on the BLOVE LA and hits the FenderRead More - Fits:
- KAWASAKI Z750FX-1
- KAWASAKI Z1000 MK2
- KAWASAKI Z750 D1
- KAWASAKI Z1R
- KAWASAKI KZ1000 A2
- ...and more.
OEM Parts Number is out of stock and I think that it has satisfactory performance as an alternative part.Leak of Oil from Z-type chronic disease from here, it is mostly fixed by exchange with this par...Read More - Fits:
- KAWASAKI Z1000 (air-cooled) 72-78
- KAWASAKI Z750 (air-cooled) 72-78
- KAWASAKI Z900 (KZ900) 72-78
- KAWASAKI Z1000 (air-cooled) 72-78
- KAWASAKI Z750 (air-cooled) 72-78
- ...and more.
Parts of this hand are unexpectedly not fitting perfectly in dimensions, but this time it was JUST. Afterwards, I would appreciate it if you bring it for about 3 years.Read More - Fits:
- KAWASAKI
- KAWASAKI
- KAWASAKI
- KAWASAKI Z2 (750RS/Z750FOUR) 72-78
- KAWASAKI Z1 (900SUPER4) 72-78
- ...and more.
Two years ago DOREMI COLLECTION was replaced by PMC so I exchanged it with PMC. I feel uncomfortable with the feeling that the winding is more complicated as compared with the OEM, so what is the dura...Read More
THE LARGEST
SHOP IN JAPAN
EXCLUSIVE COUPONS,
SALE, DEALS
FAST, RELIABLE
SHIPPING